Two-component acrylic modified cementitious waterproofing coating
Two-component acrylic modified cementitious waterproofing coating for concrete, bricks, cement plaster and masonry surfaces.
Surfaces must be free from oil, grease, wax, dirt, curing compounds and contaminants. Remove laitance by light sweep blasting, hydro-jetting or wire brushing
Shrinkage and non-moving cracks less than 0.3 mm can be bridged with a pre-treatment strip. Wider cracks should be opened and repaired with suitable Builda Rep repair products
Priming is normally not required on good quality concrete. Cementitious surfaces should be pre-soaked to saturated surface dry condition before application
Pour liquid component into the pail and gradually add powder while mixing with a spiral paddle for 3-4 minutes at 300-400 rpm until lump-free
Apply by brush, spray or trowel in the recommended coats. Allow suitable recoating interval depending on climatic conditions
